Professional tool for ball joint repairing is out now
time2022/03/22
- Professional tool for ball joint repairing is out now,Ball joint removal tools are useful for replacing the linkages that connect a control arm to a wheel hub.
What's ball joint removal tool
ball joint removal tool is a professional tool for removal/installation of press-fit parts such as ball joints, universal joint and truck brake anchor pins, even removing rusted and corroded parts.
How many types for ball joint removal tool
There are four common types of ball joint tools that can be used to separate the ball joint from the spindle. Some of these tools are very simple, others are more complicated, and which one you use often depends on the task at hand. There are also a few specialties ball joint tools that are manufacturer specific, but we’ll get into those another time.
HAMMER
You might think it sounds crazy, using a hammer to knock a ball joint out, but it isn’t. This should be the first method you try on any newer vehicle (10 or so years on the road). The trick here is to use the hammer correctly. You DO NOT hit the stud of the joint, rather you tap the side of the spindle (where the stud slides through) with the suspension loose. If the joint is reusable, then this will save it. In most cases, the stud will simply pop out of the spindle, saving you some headaches. It depends on the age of the joint, how long it has been installed, and how clean the suspension is. The longer the joint has been in use, the more likely it is for the stud to have seized in the taper.
PICKLE FORK
The most commonly known tool for separating ball joints is the pickle fork. What is essentially a long two-prong wedge, the pickle fork is also known as a part destroyer. Do not use a pickle fork on a reusable part. If you are removing the joint in order to replace or service something else, the pickle fork will only cost you more money. The reason is that you can’t save the dust boots, a fork will always rip them. If you are replacing the joint, then it really won’t matter. To use a pickle fork, simply slide it between the spindle and the control arm as tight as you can and then hit the free end with a hammer. This drives the wedge between the two points and forces the joint out of the taper.
SIMPLE CLAW-TYPE PRESS
The next type of tool is a press. This is a one-piece press that has a cast or forged two-prong claw and a threaded stud in the center. More commonly used for tie-rod joints, these can be used on ball joints. They work if the joint is not seized too bad. Cheap versions tend to not fit between the spindle and the ball joint head, and they may spread apart if too much pressure is required. Another potential pitfall is damaging the threads for the castle nut on the joint stud. To avoid this, thread the castle nut on upside down (with the split side towards the joint), and then apply the press. This keeps the head of the stud centered. This can be used in conjunction with the hammer method to put a little pressure on the joint stud as well.
BALL JOINT PRESS
The professional tool is the ball joint press. This is a more complicated version of the claw press. This tool uses a clamshell and adapters to ensure a clean and safe removal of the ball joint from the control arm. The joint will also remain reusable. The problem with this type of tool is that they are expensive; they typically cost a couple of hundred or more to get all the adapters. Just keep in mind that you will need to think ahead before you start your project if you need this tool.
